We love cross-breeding. The Rump Steak is fresh out of our lab, a hybrid of our all-around hero, The Butler, and small-wave special, The Beef Steak.
Meet The Butler. The board to make your surfing life easy. Forgiving when you want it and pushy when you need it.
Our twist on a modern retro keel twin fin. Flat rocker and a very flat deck with pinched down rails, flat in the entry into vee double concave in the bottom contour.
The RoundAbout has a low entry rocker with a forward outline for ease of paddling and down the line speed.
With a full single concave that starts in the nose and blends into deep double concave through the back half of the board in turn creating more lift and drive.
Based off of our RoundAbout, The AroundUp outline is more refined: it still has the wide point pushed a bit forward of center, but the nose area is narrower and the tail slightly pulled in to help it fit into a tighter curve.
This board was originally designed as a step down, but we have found it is a great all rounder for the 2-5 foot waves we normally surf.
A cross between the Jam and the Gasflap, this is the model if you only want to take one board to the beach. Ride it slightly shorter and wider than the Jam.
A performance shortboard that will excel in all conditions for the average to the advanced surfer.
6’2 to 8’0 The Pin Up is designed for the bigger days. Made to complement your all rounder so it is not a big step between the two.
5’4 to 6’8 A low entry rocker for easy paddling and instant speed, a deep single to double concave with a lot of bend out the tail so it fits in the curve of the wave.
5’4 to 6’2. A shorter version of the Jam, for smaller waves. We shrunk it 2 inches widened it 3/8 of an inch, pulled the pod and the nose out wider which makes the rails more parallel for great projection down the line.
The perfect small wave groveler for summer, and for the guys who don’t get to go surfing as much as they would like, designed to make surfing easy and fun.
5’4 to 6’8 A low entry rocker for easy paddling and instant speed on the get up with the channels, A deep single to double concave, with a lot of bend out the swallow so it fits in the curve of the wave
This is our new SnubV2, the original Snub was one of our very early HC models. For the new V2 we put a wing in the tail to make it wider at the 12'' mark, but also to give it a straighter outline through the mid section for drive.